Description

RANSBURG 76911-02 MODULE,SERIAL DIGITAL,STANDARD OUTPUTS

The Serial Digital Pneumatic Module converts electronic signals to eight pneumatic signals. it is packaged as a Eurocard module and fits into a Eurocard rack with a 78145 series motherboard. When configured in retrofit mode, it plugs into a 74847 motherboard. The module has an electrical connector and a quick disconnect pneumatic connector.

The Serial Digital Pneumatic Module may be commanded from any of three sources:
• Serial bus
• Discrete 24 VDC inputs (new or retrofit)
• Ransburg parallel (TTL) bus (for retrofit applications).

On the module front panel, LED’s indicate when each valve is energized. Also, the front panel switches provide momentary manual override for each valve. These front panel switches can be locked-out with an on-module switch setting or by a signal from the electrical connector.

Temperature Operating:	0 deg. to 55 deg. C
Storage:	-40 deg. C to 85 deg. C
Humidity:	95% Non-Condensing (Max.)
Size:	100 x 160mm Eurocard module, 35mm wide
Pneumatic Input Input Pressure:	0-100 psi
Burst Pressure:	250 psi
Leak Rate:	1.75 SCFM (Max.)
Req. Filtration:	10 micron
Water Vapor Content:	1.3 g/m3 (Max.)
Oil Vapor Content:	0.1 mg/kg (Oil/Water) (Max.)
Pneumatic Output Module Flow Rate:	1.9 SCFM (1 Valve On)
Valve CV Factor:	1.2 SCFM (All Valves On)
Valve Effective Area:	0.9mm2
Input Voltage:	24 VDC
Input Current:	760 mA (All valves on)
Input Current Protection:	Polyfuse (Auto Reset)