Description

Details:

The Atlas ST-7000 is the perfect lift for those car enthusiasts lucky enough to have extra tall ceilings and need to store regular height vehicles on top of extra tall vehicles. The Atlas® ST-7000 raises vehicles weighing up to 7,000 lbs. all the way to over 12 feet (144 inches) under the runway.

This super tall four post storage lift uses the same heavy duty runways found on the Atlas Garage Pro-9000. These commercial grade runways have welded jack tracks to accommodate the full line of professional rolling center jacks.

The extra tall lifting height gives customers the space needed to park much taller vehicles under the lifted vehicle. There are 21 locking positions in the lock ladder. The lock ladder may be adjusted during installation so that an almost infinite number of locking heights may be obtained.

A single point release toggle (located next to the power unit) automatically unlocks all four spring loaded pneumatic locks. Compressed air is required to disengage the locks (air supply not included). The emergency slack cable secondary lock system is always “on standby” and will engage automatically if the aircraft cables are compromised or becomes too slack.

Features and Benefits:

7,000 lb. Capacity
Atlas® Powder Coat Finish
Lifts over 12 feet high!
Perfect for storing above tall vehicles
Lock Ladder Design
Must bolt to ground
Anchor Bolts Included
Reinforced runways
Single Point Pneumatic Lock Release
Double Lock Safety System
Emergency secondary locking system
2 Year Structural, 1 Year Hydraulic Warranty
Shipping Weight: 2,866 lbs.

Included

Steel Approach Ramps
Anchor bolts

Requirements

220V 1-PH 30A
75-120 psi air supply for locks
This lift does have to bolt into place to the floor.

ST-7000 Warranty

2-year structural/1-year hydraulic
Parts Only material and workmanship 90 days on wear items.

Specifications:

Capacity	7,000 LB
Lifting Height To Top Of Runway	147″ (12′ 3″)
Overall Length with Approach Ramps	227 ½” (18′ 11 ½”)
Overall Length without Approach Ramps	205 ¼” (17′ 1 ¼”)
Length Between Columns	185″ (15′ 5″)
Overall Width (With Motor)	123″ (10′ 3″)
Overall Width (Without Motor)	110 ½” (9′ 2 ½”)
Approach Ramp Length	31 ½” (2′ 7 ½”)
Total Runway Width	19″
Runway Length	194″ (16′ 2″)
Runway Thickness	4 ½”
Width Between Runways	45″ (3′ 9)
Width Between Runway Rails	41 ¾” (3′ 5 ¾”)
Outside Runway to Outside Runway	83″ (6′ 11″)
Clearance Under Runways	142″ (11′ 10″)
Size of Column	7 ½” x 4 ½”
Clearance Between Columns	100″ (8′ 4″)
Base of the Column	11 ¾” x 13″
Height of Columns	162″ (13′ 6″)
Maximum Wheel Base	182″ (15′ 2″)
Drive Thru (Outside of tire to outside of tire)	82 ½” (6′ 10 ½”) Adjustable by 7 ½”
Cable Diameter	.625″ (5/8″)
Gauge Of Steel	5 Gauge (.2″ / 1/5″ / 5mm)
Motor	220V +/- 5% (209-231volts) 1 phase. A 30 amp breaker is required.
Oil Requirement	6 Gallons AW32/AW46
Shipping Weight	2,866 LBS.